User's Manual

Quanzhou Wanneton Electronic&Technology Co.,Ltd

Baijie International Centre ,Qiaonan District, Chidian Town, Quanzhou, China

Dual Standby

When in dual standby mode, the radio can receive the A or B channel.

Standby mode, Press [MENU][7]（or press the []/[] key）to enter “Dual Standby”, Press[MENU]selection：

• Turn off the function: Press []/[] key and select OFF to turn off the dual standby function.

• Turn on the function: Press []/[] key and select ON to turn on the dual standby function.

In dual standby mode, the radio is in the scanning state of main and secondary channels. Even if the power saving

function is enabled, the power saving function is still invalid, and the standby time of the interphone will be shortened.

Memory channel

1) When the transceiver works in the channel mode, it is able to copy all the parameters except the channel names into the

specified channel.

2) When the transceiver works in the frequency mode, set the offset frequencies, shift direction and other parameter

ahead, and then save into the specified channels.

3) Same frequency saved in one channel

For example, specified channel CH-20, same frequency 435.125MHz, RX CTCSS 67Hz, TX CTCSS 67Hz.

Setp 1, input [4][3][5][1][2][5] in the frequency mode.

Setp 2, press [MENU]+[1][2]+ [MENU] to start setting RX CTCSS, use [UP]/[DN] to select 67.0, and then press [MENU] to

confirm.

Setp 3: press [MENU]+[1][4]+ [MENU] to start setting TX CTCSS, use [UP]/[DN] to select 67.0, and then press [MENU] to

confirm.

Setp 4: press [MENU]+[2][6]+ [MENU], then use []/[] key to selecting the desired channel CH-20 to memory.

Finally，press [MENU] to confirm and finish.

If tone is not needed, then the step 2 and 3 are not necessary.

4) Memory channel in different TX and RX frequencies. This is working for repeating communication.

For example, specified channel CH-20, RX frequency 435.125MHz, TX frequency 445.125MHz, RX CTCSS 67Hz, with TX

CTCSS 67Hz.

Setp 1, input [4][3][5][1][2][5] in the frequency mode.

Setp 2, press [MENU]+[2][5]+ [MENU] to set the offset frequency 10.000MHz.

Setp 3, press [MENU]+[2][4]+ [MENU] to set the direction to “Plus”.

Setp 4: press [MENU]+[2][6]+ [MENU], then use []/[]key to selecting the desired channel CH-20 to memory.

Finally，press [MENU] to confirm and finish.

■Technical Specifications

Frequency Range

Rx:136-174/400-480MHz Tx:144-148/420-450MHz