Operation Manual

Wanscam IPCAM User Manual
10. Running the Search Tool software, If network cable and power supply are correctly
connected, device type, name and IP address will be shown in the Equipments list
(Otherwise, please confirm whether power supply and network cable work normally).
In the picture above, the configuration information of the current computer is listed on
the left side; and the network configuration information of the selected device is listed on
the right side. Default IP address of the IP camera is 192.168.1.99, and HTTP port is 99.
From the Search Tool, Select your IP camera. Here, you will need to re-address your
camera’s IP address based off of your Local Network Default Gateway. For example: If
your Default Gateway is 192.168.1.1, you should change the last set of values of your
address from 1to a larger value such as 99. Therefore, your new address will read
“192.168.1.99” (The last set of values must be lower than 254).
11. Next, change the Gateway and DNS IP address in the network setting to exactly
match your Default Gateway.
12. Now Change the Data Port to 80.
13. Last click “Apply” enter the Username and Password. The Username will be “admin”
and the Password field will remain empty.
14. Last, click “OK” and your camera will automatically reboot as it saves all changes
that you have just mode.
11