Operation Manual

Wanscam IPCAM User Manual

When installing the camera to the local network for the first time, the camera must be

connected to an Ethernet input on your router so that your network can locate your

camera.

1. Power on the camera in close proximity to your router.

2. Directly connect your camera to your router using the Ethernet cable.

If the yellow and green indicator lights on the camera are blinking, then your camera is

successfully communicating with your router.

3. Insert the software CD (included ) into your PC.

4. Run the program labeled “ OCX Setup” form the flie folder on the software CD.

5. After the “OCX Setup” program has installed. Please run the “ Search Tool” software.

This software is used to search the IP address of the ip camera in your local network.

Note: “ Search Tool” Software no need to install, if you need it , you can copy it to your

desktop of your PC.