User Manual

PALM GARDEN ENTERPRISES CORP.
17
FAQ
1. Q : Why can’t I create a connection to the receiver?
A :
(1) Verify that the battery power of receiver is not running low.
(2) Check if the receiver is powered on and the AV / HCI dongle plug in the
USB port.
(3) Verify that the receiver is within the specified range of 10 meters from the
dongle.
(4) Check if any other Bluetooth device has connected to the receiver.
(5) Turn off the receiver and unplug the AV / HCI dongle device. Power on the
receiver and plug in the AV / HCI dongle and try connecting again.
2. Q : Why is the status LED indicator of AV / HCI dongle light up steadily?
A: When the AV / HCI dongle is on the cell phone mode, the status LED
indicator will light up steadily.
3. Q : How can I change the modes?
A: You can change AV mode to HCI Mode by the slide switch, and vice versa.
Dual mode dongle may probably malfunction when you "hot swap". If you
want to make a switch, please pull out the dual mode dongle and plug it in
the USB port again to make sure the successful switch.