PROFESSIONAL POPCORN MAKER WPM30/55 Series For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
IMPORTANT SAFEGUARDS When using any electrical appliance, basic safety precautions should always be followed, including the following: 1. READ ALL INSTRUCTIONS BEFORE USING YOUR POPCORN MAKER. 2. Unplug main power cord from outlet while not in use and before cleaning. 3. To avoid any risk of electrical shock, do not immerse cord or plug into water or other liquid. 4. This appliance should not be used by or near children, or individuals with certain disabilities. 5. Do not touch hot surfaces.
14. Do not place the unit on or near a hot gas or electric burner or in a heated oven. 15. Extreme caution must be paid when moving the appliance containing hot oil or other hot liquids. 16. Turn ALL switches to OFF position before disconnecting power plug from the wall supply outlet. 17. Not recommended for outdoor use. 18. Do not use appliance for other than intended use. 19. To avoid overheating, always add oil and then kernels before operating. 20.
Parts 1. Housing 2. Kettle 3. Door (removable) 4. Door Panel (removable) 5. Tray (removable) 6. Measuring Spoons and Scoops 7.
Assembling PRocedure Figure 1 Figure 2 Hook the kettle onto the hanging brackets in the main unit. Apply bottom door panel to unit. Figure 4 Plug kettle electrical cord into the socket on the inner top of the popcorn housing. Screw in light bulb. (Note: Heat lamp/light bulb is packed separately) Figure 3 Slide tray into bottom of unit.
POPPING INSTRUCTIONS 1. Make sure the popcorn maker unit is unplugged before you do any of the following. 2. Before using the unit, please check carefully if voltage (120V – 60 Hz ) is suitable to your home. 3. Clean the internal surface of the kettle with warm sudsy water; rinse well and dry with a clean cloth. Wipe down inner and outer housing with a damp cloth. 4. Main unit has 2 function switches as follows: – Light/Warmer combination switch – POP switch to turn on heater and stirrer 5.
13. Keep POP switch off if the unit is not continuously in use. 14. Keep only the Light/Warmer switch on. 15. Remove plug from power supply if the unit is not being used. 16. Repeat steps 9 to 14 for continuous popping. Cleaning and Maintenance It is strongly recommended to clean the kettle frequently to avoid burning excess oil onto the bottom of the inner pot. After using the popcorn machine, when the machine has sufficiently cooled, use a wet cloth to clean the main unit, main body and glass.
Any other trademarks or service marks of third parties herein are the trademarks or service marks of their respective owners. ©2009 Conair Corporation Waring Consumer Products, Division of Conair Corporation 150 Milford Road East Windsor, NJ 08520 www.waringproducts.