Hot Dog Griller HDG150 For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
Important Safeguards Basic safety precautions should always be followed when using electrical appliances, including the following: 1. Read all instructions before using. 2. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance. 3. Do not touch hot surfaces. Use handles or knobs. 4. To protect against electrical shock, do not immerse the appliance, cord or plug in water or other liquids. 5.
Save these instructions for Household Use Only NOTICE This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. Before Using Clean 1. Remove all packaging materials. 2. Wash the drip pan and cover with warm soapy water using a sponge or dishcloth.
3. Cover 1. Body 4. Power Switch 2. Drip Pan Parts 1. Body 2. Drip Pan The drip pan is used to catch oil and pieces from the roasted hot dogs. 3. Cover To remove cover, grasp both sides of cover and lift up. Cover should always be in open position when grilling. 4. Power Switch The power switch has as three functions: HI, OFF and LO. Plug the power cord into proper wall outlet, then press up to the HI position. The rollers will begin to heat and turn.
How to Use After initial preheating and before first use, follow the steps below: 1. Place the drip pan into the body. Open the lid. 2. Plug power cord into proper wall outlet. 3. It is recommended to preheat grill for 5 to 8 minutes before adding hot dogs. Press HI to start rollers turning. Red light will turn on. It will take approximately 5 minutes for unit to heat up. Place hot dogs on rollers. 4. Check the progress of the grilling frequently.
CLEANING AND MAINTENANCE After Use 1. Allow the unit to cool completely before cleaning. 2. Press switch to LO. When rollers begin to turn, take sponge or dishcloth and wipe clean. 3. Turn to OFF. 4. Disconnect the plug from the wall outlet. 5. Wash the drip pan and clip with warm, soapy water using a sponge or dishcloth. NOTE: Do not put in dishwasher. Hand wash only. 6. Rinse thoroughly to remove soap residue. 7. Wipe body clean with a damp cloth. • C over is removable for cleaning.
NOTES 6
©2011 Waring Consumer Products 150 Milford Road East Windsor, NJ 08520 www.waringpro.