Instruction Booklet

6
CLEANING & SANITIZING INSTRUCTIONS
TO WASH:
1. TURN UNIT OFF USING POWER SWITCH LOCATED ON
BACK OF UNIT, OR UNPLUG MIXER POWER CORD FROM
ELECTRICAL OUTLET.
DO NOT PUT IN DISHWASHER.
2. To remove the bottom cup supports (C), simply push each
support up, then pull out toward you.
3. To remove the upper cup supports (D), rmly hold the notches on
both sides of the support, then pull directly out from the base.
Use only low-foaming detergents formulated for cleaning
dishware and cooking utensils. These products can be purchased
from restaurant and commercial food-service suppliers. Follow
the detergent manufacturer’s instructions.
Add 12 ounces of washing solution to mixing cup and place
in normal operating position on mixer.
Run on LO speed for a minimum of two (2) minutes.
Empty cup and repeat two-minute run with 12 ounces
of water on LO speed.
Empty cup and repeat two-minute run with 12 ounces
of sanitizing solution on LO speed.
Empty cup. Run motor for a few seconds with empty cup in
normal operating position to spin off any excess moisture.
Do not rinse cup, spindle or agitator after sanitizing is
completed. Allow all parts to air-dry.
Reassemble ON/OFF cup actuator and mixing cup supports
to mixer housing by reversing above steps 2 and 3.