Owner Manual

17
3) Press any number button to enter related mode setting.
For example: To set the buzzer to a medium level, press 2.
Display shows OP:22. To change, keep pressing 2. Screen
displays cycles through OP:20, OP:21, OP:22, OP:23, before
cycling back to OP:20.
4) Press START to save the displayed setting. OP: - - will be
displayed again.
5) During this process, press STOP to enter Door Open Mode.
Closing the door will return oven to Ready Mode.
6) If START button is not pressed as the last step, the program
will not be saved.
SERVICE MODE
1) Open the oven door and press and hold the number button 3
for ve seconds to enter Service Mode.
2) Screen displays SERVICE.
3) To check the number of hours and number of cycles that the
components have run, press the following:
– Press 1 for Tube hours
– Press 2 for Tube cycles
– Press 3 for Door cycles
– To reset: Press 4 and then START. 4-CLEAR will be displayed.
– Press 5 to check the Top Magnetrons. The Screen will display
the amount of amps.
– Press 6 to check the Bottom Magnetrons. The Screen will
display the amount of amps.
4) Press STOP to enter Door Open Mode. Close the door to enter
Ready Mode.
FACTORY-DEFAULT SETTING
To return the oven to its factory-default setting, follow the
steps below:
1. With oven in Ready Mode, press START and 0 at the same time.
2. The buzzer will sound once and screen will display CHECK.
NOTE: If the oven is currently in the factory-default setting, the
screen will display 11, and after 3 seconds will return to the
Ready Mode.