Operation Manual Quik Stik Plus® Immersion Blender WSB40 For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
Important Safeguards GROUNDING INSTRUCTIONS When using an electrical appliance, basic safety precautions should always be followed, including the following: For your protection, the Waring® Quik Stik Plus® Immersion Blender is supplied with a molded 3-prong grounding-type plug, and should be used in combination with a properly connected grounding-type outlet, as shown below. READ ALL INSTRUCTIONS. 1.
BEFORE YOU BEGIN NOTE: Always unplug the Waring® Quik Stik Plus® Immersion Blender before cleaning the metal blade. Before using the Quik Stik Plus™, Waring suggests that you wipe the unit with a clean, damp cloth to remove any dirt or dust. Place the metal blade end of the hand blender under running water to rinse it. Dry thoroughly with a soft absorbent cloth. Read all instructions completely for detailed operating procedures.
WARRANTY To wash and sanitize the Quik Stik Plus®: 1. Rinse the exterior and interior stainless steel portion of the Quik Stik Plus® under running water. Scrub and flush the exterior and interior stainless steel portion to dislodge and remove as much food residue as possible. 2. Wipe down the exterior of the plastic housing and the stainless steel portion of the Quik Stik Plus® with a soft cloth or sponge dampened with the washing solution. 3.
©2009 Conair Corporation Waring Commercial 314 Ella T. Grasso Ave.