Instruction Booklet

9
2. For U.S., 120V hot water dispensers are provided with a
120V/15A grounding plug. For Canada, 120V/20A grounding plug.
Units must have a separate 120V/15A outlet.
TESTING THE CONNECTION/BEFORE FIRST USE
1. We recommend running at least one cycle before rst use.
2. Open water supply line valve to hot water dispenser.
3. Turn on or plug in the power supply to the hot water dispenser.
The unit lls at the approximate rate of 1 gallon (3.8 L) per minute
depending on water line pressure.
4. Heat and discard at least one tank of water.
DEFAULT SETTINGS
• Temperature: 150°F/ 65°C
• Unit of measurement for temperature: Fahrenheit
• Water connection: Auto Fill/plumbed into water supply
• Night mode temperature: xed at 158°F (70°C)
OPERATING INSTRUCTIONS
SETTING THE TEMPERATURE
1. Press button once.
2. Use the arrows to reach your desired temperature.
3. Once desired temperature is displayed, press the button
to set or wait 10 seconds to set new temperature.
4. Display will show set temperature and PRESS START blinking.
5. Press to begin lling and heating water.
CAUTION: Water is very hot. Use caution when pouring or
transporting hot water. Accidental spills may result in severe burns.
SETTING °F/°C
1. Press button once.
2. Once in program mode, PRESS and HOLD the button
for 2 seconds.
3. Use the arrows to switch from F to C.
4. Once desired unit of measure is selected, press twice
to set.
5. If neither button is pressed for 15 seconds, then the F or C
displayed will be programmed.