Operating instructions

08/04/2008 13 EI709
Load Control, Other Products or Hardware
If there is a need to “pass on” the utility load control receiver function to other heating equipment, radiant
floor boiler, peak interrupter, etc; there is an isolated contact on this control board. Locate tabs
COM/EL/SB. In the electric mode there is an isolated contact between COM and EL. This contact is for
low voltage only, 1-amp maximum.
Note: There may be a 1 or 2 minute delay between this relay contact action and the actual load
control receiver. This delay coincides with various blower purge functions.
Note: This contact also following front panel standby switch.