Installation Guide

The Customized Installation Plan
This is your key to a successful installation. Your plan has been custom designed
for your individual project based on the dimensions you gave us. It will indicate the
placement of each Heating Roll, the electrical service requirements, and the location
of the control device(s). It should be reviewed to verify that the dimensions of your
room are accurate as well as the location of the permanent xtures in your space. If
you have made any alterations to your oor plan, contact WarmlyYours to have
your Installation Plan updated.
A. Materials List:
Indicates the items included in your order.
B. Legend:
Description of the items on the Installation Plan.
C. Starting Point:
Indicates where the Heating Roll(s) starts.
D. Ending Point:
Indicates the end of the Heating Roll(s).
E. Turn:
Indicates where the “Mesh” needs to be cut to make a turn allowing the roll to continue
in a new direction. See Page 5 for full details on how to execute turns.
F. Free Form Space:
Indicates a length of Fiberglass Mesh that needs to be removed and separated from the
Heating Element. For every 3” of Mesh removed, 1’ 6” of Heating Element will be freed
on 18” wide rolls, and on 36” wide rolls, 3’ of heating element will be freed. This “free” wire
should be manually positioned on the oor and secured with tape or glue. Staples are
never recommended on the Heating Element.
G. Control Device:
Indicates where the control device is to be located on the wall.
H. Notes:
Indicates any additional information you may need including the total watts and amps
drawn by the Floor Heating System.
I. Permanent Fixtures:
Indicates the location of permanent xtures. Please note that these xtures must not be
placed on top of the heated area.
IMPORTANT - Cross check the items you received against the packing
list and the materials list on the installation plan to ensure that the roll
length(s) and thermostat type(s) are an exact match.
Understanding The Customized Installation Plan
3