Specifications

Product Construction - Towel Warmer
Depending on the model, the towel warmer is constructed from
high carbon steel or stainless steel with a wall thickness of
between 0.8 mm and 1.2 mm. The steel tubing is brazed together
with full, continuous joints. The fi nished assembly is electroplated,
polished, or brushed, depending on the model and style. The towel
warmer is heated with a heating element. The mounting brackets
are manufactured from steel and fi nished to match the fi nish of the
specifi c model.
Product Construction - Control
The Timer is humidity sealed to IEC standards for zone 1 (areas
where it may be splashed by water) and zone 2 (areas which are
occasionally subject to high humidity) and therefore suitable for
installation in damp locations such as bathrooms.
Connection Method
The heating wire is connected to a non-heated lead by a mechanical
crimp connection, sealed with a heat shrink tube. Electricity is fed
into the Towel Warmer via a threaded adjustable nipple. The nipple
is adjusted so that it fi ts securely to the front of 2”x4” electrical
junction box. This box is secured in the wall and a water resistant
seal is made with the use of a rubber O-ring. Power can then be
fed to the control unit which may be located anywhere in the room.
Safety Ratings
The main electrical line feeding the Towel Warmer must incorporate
an Appliance Leakage Current Interrupter (ALCI) for North
America.
13