Installation Guide

2. Bracket Assembly Instructions (continued)

Step 1

Measure for bracket positions using the template if desired. At least two brackets

must be attached to a stud.

Step 2

Ax brackets A to the wall using screw g and drywall anchor f where necessary.

Repeat Step 2 for the three remaining brackets.

Step 3

Place and orient the curved end of tubing B with the threaded inserts located at

four points on the back of the towel warmer. Ax tubing B to the threaded inserts

with bolt C and tighten using the large Allen wrench d provided.

Repeat Step 3 for the three remaining sections of tubing.

Step 4

Loosen the hex-head screws h at the base of each section of tubing B using the

smaller Allen wrench e provided. Hang towel warmer by aligning and sliding all

four sections of tubing B over bracket A. Partially tighten hex-head screws h at

the base of each section of tubing B to hold the towel warmer in place but do

NOT fully secure the fasteners at this time.

Step 5

Please remove the protective lm from the cover plate.

Plug-In Model Skip Steps 6-8.

Hardwired Model Only

Slide the brushed stainless collar over the end of the stainless steel tubing where

the wires come out of the unit. Make sure to slide the collar over the tubing

so that the larger diameter opening is facing away from the towel warmer and

toward the electrical cover plate that will be placed on the towel warmer next.

Remove the plastic coating from the cover plate. Slide the cover plate over the

same section of stainless steel tubing. Refer to Diagram E. Do not remove

rubber O-ring from electrical plate under any circumstances. Make sure the

cover plate is slid on the tubing so that the back of the cover faces away from the

towel warmer and toward the electrical outlet.

Step 6

Have a certied professional wire the towel warmer to the electrical circuit according

to code, referring to the detailed wiring diagram provided in Diagram F.

Step 7

Push the wires into the electrical box and screw the cover plate to the outside of

the box with the screws provided.