Instructions / Assembly
Product Construction - Towel Warmer
Depending on the model, the towel warmer is constructed from
high carbon steel or stainless steel with a wall thickness of between
0.8 mm and 1.2 mm. The steel tubing is brazed together with full,
continuous joints. The towel warmer is heated by a UL listed wire.
The mounting brackets are manufactured from stainless steel and
nished to match the nish of the specic model.
Connection Method
The heating wire is connected to a non-heated lead by a mechanical
crimp connection, sealed with a heat shrink tube. Electricity is fed
into the Towel Warmer via a threaded adjustable nipple. The nipple
is adjusted so that it ts securely to the front of 2”x4” electrical
junction box. This box is secured in the wall and a water resistant
seal is made with the use of a rubber O-ring. Power can then be
fed to the control unit which may be located anywhere in the room.
Safety Ratings
The main electrical line feeding the Towel Warmer must incorporate
an Appliance Leakage Current Interrupter (ALCI) for North
America.
10