Instructions / Assembly

Afxing the Towel Warmer to the Wall

Step 1

Draw a diagram of the preferred location of the brackets and the

electrical connection on the Towel Warmer box to create a template

(see Step 2 for template instructions). At least two of the four

brackets must be attached directly to a stud.

Step 2

Create the template:

A. Attach brackets into desired positions on the Towel Warmer

(see pages 5-6 for bracket assembly for each model).

B. Place Towel Warmer on the box (or a large sheet of paper) and

lay on a at surface with brackets facing downwards.

C. Mark the location of the following:

• the electrical collar

• the location of the brackets

D. Use the template as a guide to mark the wall with the correct

locations of the four brackets, ensuring the following:

• the electrical collar is lined up with the center of the

electrical box

• at least two of the brackets are lined up with a wall stud

• the Towel Warmer is level

Step 3

Install the brackets onto the wall. Use the drywall anchors that are

supplied for the brackets that are not being installed into a stud.

Refer to Appendices A1-A2 for the Rough-in Diagram for each

model.