Instructions / Assembly
Final Installation Instructions - cont’d
Step 11
Have a certied professional wire the Towel Warmer to the electrical
line according to code, referring to the detailed wiring diagram
provided in Appendix B.
Step 12
Push the wires into the electrical box and screw the cover plate to
the outside of the box.
Step 13
Screw the adjustable collar out and tighten it against the faceplate
on the electrical box, ensuring the rubber seal is in position and
sealed correctly inside the collar. Refer to Diagram B.
Step 14
Fully tighten the screws for the brackets.
Step 15
Remove plastic caps from vertical bars (if present).
Step 16
Locate switch on the bottom of the left vertical bar, and toggle to
the “on” position.
Step 15
Switch on the power by touching the “on” button, of the controller,
to conrm that the control is operable. In approximately 10-15
minutes, your Towel Warmer will be warm to the touch. Refer to
Diagram C.
8