SDS

70℃
20℃
-20℃
0.5h 0.5h 2h 0.5h 4h 0.5h
Manager
Check
Approval
※ Caution
SPECIFICATIONS
Tel:[phone]
Lihui Chen
HangJun Wu
4/F, Hongwan Commercial Building, 4235# Bao'an
District，518126, Shenzhen
http://www.allkeybattery.com
JunPing Liu
9.3) External short circuit
Undischarged battery shall be connected directly +/- polarity with resistance of the interconnecting circuitry
shall not exceed 0.1Ω. The circuit shall be completed for 24hours
Requirement) The batteries should be no explosion during this test.
During this test battery surface temperature is raise near 100℃ within five minutes.
Do not touch the battery surface during this test about 1hour, if not may occur skin injury.
5) Repeat the sequence for a further nine cycles
6) After the 10th cycle, store the batteries for seven days prior to examination.
Requirement) Batteries shall be no explosion during this test.
4h
1cycle (repeat 10 times)
9.2) Climatic-temperature cycling
1) Place the batteries in a test chamber and raise the temperature of the chamber to 70±5℃ within 30
and maintain the chamber at this temperature for 4hours.
2) Reduce the temperature of the chamber to 20±5℃ within 30min and maintain for 2hour.
3) Reduce the temperature of the chamber to -20±5℃ within 30min and maintain for 4hour
4) Raise the temperature of the chamber to 20±5℃ within 30min
9.1) Storage After Partial Use
This test simulates the situation when an appliance is switched off and the installed batteries are partly
discharged. These batteries may be left in the appliance for a long time.
Method) Undischarged battery is discharged during 2hours by 5.1Ω continuous (about 50% of MAD) and
followed by storage at 45±5℃ for 30 days.
Requirement) After storage battery shall be no leakage and no explosion during this test.
Part No.
ALLKEY-LR03-2017
Page
8/9
9. Safety test for intended or reasonably foreseeable misuse
Approved Date
2017/1/3
Part Name
Alkaline Primary Battery - LR03   
Version
C/0
Prepared Date
2017/1/3