Owners manual

WARN Page 3 61772 Rev. A0
shown in Photo 2. This is easy to do by removing the ten allen head screws, pulling the housing out about 1/8”
and then rotating exactly two bolt holes. Reinstall and tighten the screws.
4. Prior to installing the winch on the Mounting Plate, refer to Photos 3 & 4 attach the ground wire to the motor.
Also install the Control Pack Bracket to the Mounting Plate. Now install the winch, control pack and roller
fairlead using the instructions and fasteners packaged with the winch.
5. Install the complete assembly up to the vehicle frame. A floor jack is suggested. See Photos 5 & 6. Once
again, use the spacer washers if not installing a light bar or other guard. Use the “nuts with handle” inserted
thru access holes in the frame. Leave fasteners slightly loose. Install Braces as shown. Now tighten all
fasteners securely.
Rotate
clutch
housing
clockwise
Photo 2
Photo 3 Photo 4
Attach control pack
ground wire
Control Pack Bracket