Owners manual

WARN Page 4 61772 Rev. A0
6. Route the battery cables up to the battery as follows: The red (+) cable should exit the control box and be
routed to the rear between the winch motor and the tubular crossmember. Bring the black (-) cable up to meet
the red and tie wrap them to the vehicle wiring harness just under the radiator shroud. Route them towards the
left and over the top of the left frame rail, then up towards the battery. Make the connections to the side
terminal battery using the supplied hardware shown in the following diagram. Use the tie wraps to secure the
cables away from sharp edges and moving parts.
Photo 5
Photo 6
Spacer Washers used here unless
Light Bar 61090 or other grille
guard bracket can occupy the ¼”
space.
Insert nut with handle
thru access holes
Brace