User Guide

987604A1.doc Page 39 of 48
WIRING DETAILS
• Route black lead Wire from J3 terminal on Circuit Board through Wire guides up into handle
to Trigger Switch.
• Route black lead Wire from J2 terminal on circuit board through Wire guides up to Rocker
Switch.
• Route white lead Wire from J4 terminal on circuit board through Wire guides up to Trigger
Switch.
• Route the Motor wires as shown.
• Route Brush leads from Brushes up to Trigger Switch.
• Use tie strap to secure Motor Wires and Brush Wires to the right hand frame.
• Attach green Wire from Power Cord assy. to frame as shown.
• Refer Wiring diagram 74862 for installation Wiring schematic.
Switch Pin-out Table
Manufacturer name is embossed on switch.