User Guide

987604A1.doc Page 47 of 48
Motor does not run. Faulty Trigger Switch
Defective Motor
Repair or replace Switch
Replace Motor
Loose connection of the
Wires to be Motor terminals.
Secure the Motor terminal and
Wires.
1.6 Electrical sparks
appear around
Motor.
Switch held in power-in
position while PullzAll is
stalled.
Replace Wire harness or Motor
Assembly.
1.7 Wiring harness
insulation has
melted.
Poor installation caused Wire
insulation to be rubbed off or
cut, causing direct short.
Replace Wiring harness.
1.8 PullzAll makes
squeaking / high
pitch noise.
1.9 Full speed only, no
variable speed control
Drum Bushing not lubricated.
Ensure trigger is only
partially depressed
Grease Drum Bushings.
Replace Variable Speed Trigger
switch
1.10 Malfunctioning Not operating correctly. Cease operation. Diagnose, Repair
or Replace.
INSPECTION
VISUAL INSPECTION:
• While disconnecting the connectors, never pull the wiring Harnesses. Unlock the connector
first and then pull them apart by holding connectors themselves.
• While connecting connectors, also hold connectors and put them together until they lock
securely (a click is heard).
• While Installing the Wiring Harness, fix it with clamps so that no slack is left.
• While using a tester for checking continuity or measuring voltage, be sure to insert the tester
probe from the wire harness side.