2 Volt Load Control for Electric Brake Systems No.
The Warner Electric Load Control provides the capability to properly proportion the braking power of the trailer brakes to the trailer weight. The Load Control is a variable resistor which allows the operator to reduce current flow to the trailer brakes by turning the control knob. Depending on road conditions and trailer load, the knob can be set at any position between “MIN BRAKE” and “MAX BRAKE”. The Load Control provides a broad range of adjustment to suit a wide variety of operating conditions.
NOTE: Use only 10 or 12 gauge wire meeting SAE Specification J558a for connecting the Load Control. Strip the insulation back about 1/4" from each cut end. Insert one stripped end into each of the two insulated ring terminals provided. After inserting the full length of bared wire, crimp the terminal using AMP hand tool 59239-4 (G9150-7 for thinwall insulation) or equivalent. Assemble the wired terminals to the Load Control, but do not tighten.
Warranty Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any product manufactured and sold by it which proves to be defective in material or workmanship within a period of one (1) year from the date of original purchase for consumer, commercial or industrial use. This warranty extends only to the original purchaser and is not transferable or assignable without Warner Electric LLC’s prior consent. Warranty service can be obtained in the U.S.A.