Manual

Autogap Installation for Automatic

Adjustment of Armature Clearance

Drive Hub

Yellow Spring

Detent Ring

Detent Retainer

Armature

Spring Retainer

Blue Spring

Retainer Ring

Drive Pin

Installation & Operating Instructions

P-1421

819-0386

PART NO. 5250-101-009

Assembly Instructions

Step 1: Place detent retainer and yellow

spring onto threaded end of drive

pin with detent as shown above.

Step 2: Apply "Loctite" #242 in threaded

pin holes of drive hub.

Step 3: Place drive pins into the drive hub

holes and tighten to 45-50 lb.ft.

torque. Be sure the yellow springs

are not caught under the shoul-

ders of the pins.

Step 4: Place armature over the pins so

the pins protrude thru the bush-

ings in the armature.

Step 5: Place spring retainers and blue

springs on pins as shown and

secure with retainer rings.

Step 6: Push the armature away from the

hub toward the top of the pins as

far as possible. All detent retain-

ers must then be pushed against

the armature bushing flanges.

Failure to follow these

instructions may result in product dam-

age, equipment damage, and serious or

fatal injury to personnel.

PAGE 1
Autogap Installation for Automatic Adjustment of Armature Clearance P-1421 819-0386 PART NO. 5250-101-009 Installation & Operating Instructions Armature Detent Retainer Spring Retainer Blue Spring Detent Ring Yellow Spring Drive Hub Retainer Ring Drive Pin Assembly Instructions Step 1: Place detent retainer and yellow spring onto threaded end of drive pin with detent as shown above. Step 5: Place spring retainers and blue springs on pins as shown and secure with retainer rings.
PAGE 2
Warranty Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any product manufactured and sold by it which proves to be defective in material or workmanship within a period of one (1) year from the date of original purchase for consumer, commercial or industrial use. This warranty extends only to the original purchaser and is not transferable or assignable without Warner Electric LLC’s prior consent. Warranty service can be obtained in the U.S.A.