Spring-Set Brake Module P-1249 819-0390 Installation Instructions
The Warner Electric Spring-Set Brake Module is designed to function as a holding brake for NEMA C-face motors. The brake is self-engaging when the power is turned off or unintentionally interrupted. It is to be mounted between a C-face motor and a C-face gear reducer. Do not apply overhung or side loads to the output shaft of the Spring-Set Brake Module. Failure to follow these instructions may result in product damage, equipment damage, and serious or fatal injury to personnel.
6. Secure the brake module to the motor C-face with the four hex head capscrews and washers that are provided. (Figure 3) 7. Rotate the brake housing to align the four mounting holes with the threaded holes in the motor face. If possible, position the brake module with the ventilation slots facing down to prevent foreign matter from falling into the unit during operation. 8.
Warranty Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any product manufactured and sold by it which proves to be defective in material or workmanship within a period of one (1) year from the date of original purchase for consumer, commercial or industrial use. This warranty extends only to the original purchaser and is not transferable or assignable without Warner Electric LLC’s prior consent. Warranty service can be obtained in the U.S.A.
