User Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone [phone]
Fax [phone]
[e-mail]
RECEIVER HITCH
INSTALLATION INSTRUCTIONS
WAR 1085
1. Remove bottom bumper bolts; threaded upwards into bottom of frame.
2. Slide hitch up alongside frame rails, reinstall bumper bolts through hitch
into frame to hold hitch in place. DO NOT TIGHTEN.
3. With a _” box end wrench, feed supplied _” nut through hole in bottom
of frame to upper hole, (step #3, figure #1) thread bolt into nut.
DO NOT TIGHTEN.
4. Install nut and bolt (step #4, figure #1) into lower center hole.
DO NOT TIGHTEN.
5. Tighten the 2 bolts on each side of frame to 65 ft/lbs. Tighten bottom
bumper bolts to 65 ft/lbs.
6. Using a _” drill bit, drill through frame using hitch hole as a guide (step
#6, figure #1).
7. Install last bolts through drilled hole. Tighten to 65 ft/lbs.
8. After test drive re-torque all bolts.
Do not exceed Vehicle Manufacturers Recommended Towing Capacity!
*Load Capacity 2,500 – 5,500 lbs.
If you need further assistance installing your product, please contact us by email at
[e-mail] or call us at [phone].
THANK YOU FOR PURCHASING WARRIOR PRODUCTS