Owner's manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone [phone]
Fax [phone]
[e-mail]
TUBE DOOR MIRROR BRACKET
INSTALLATION INSTRUCTIONS
WAR 1518
NOTE: These mirror brackets will fit all JK Wrangler Front Tube Doors as well as Front Tube Doors
for all Cherokee XJ Models. This kit also requires the purchase of any 97-02 Early Model TJ Mirror Set.
Installation:
1. These brackets mount to the outside of the triangular gusset located on the top hinge pin of your
tube doors. They should be located so that the tube on the mirror bracket sits outside of the door
when installed on the vehicle.
2. Start by aligning the brackets on the gusset of the tube door and marking the locations to be
drilled. A silver or white colored pencil draws very well on the black powder coat. You should
be marking 3 holes on each side for a total of 6 holes.
3. Drill the marked holes with a 9/32” drill bit. To do this it is recommended that you first center
punch the marked holes so that the drill bit does not wander. You can choose to use some flat
black paint to retouch the drilled holes. Allow to dry completely before continuing.
4. Using the six bolts and nylock nuts included in your kit, bolt the brackets onto the tube door
gusset. The two short bolts go behind the mirror tube mounts, one for each side.
5. The 97-02 Wrangler mirrors you have purchased to do this installation should have a stud on the
bottom with an included nut. Remove the nut and slide the mirror into the tubular opening on
the bracket, allowing the threaded portion of the stud to slide into the hole in the bracket. Re-
install the nut included with your mirror and tighten to a snug fit.
6. Sitting in your driver seat with the tube door closed; set the mirror’s angle to the desired position
and lock it into place by tightening the mirror to the bracket securely. Do not over tighten as you
may damage the mirrors.
7. Finish the installation by hand adjusting the mirror lens to your preferred position.
Warrior also carries a full line of mesh covers, padding kits, and door limiting straps for your Tube
Doors. Check out www.warriorproducts.com to view additional accessories available for your tube
doors.
If you need further assistance installing your product, please contact us by email at
[e-mail] or call us at [phone].
THANK YOU FOR PURCHASING WARRIOR PRODUCTS