User Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: [phone]
Fax: [phone]
[e-mail]
www.warriorproducts.com
30721 2” ECONOMY LIFT KIT
INSTALLATION INSTRUCTIONS
Warrior recommends this system be installed by a certified technician. In
addition to these instructions, professional knowledge of
disassemble/reassembly procedures as well as post installation checks must
be known. Attempts to install this system without this knowledge and
expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit
hardware against the parts layout and list found on the last page of these
instructions. Be sure you have all needed parts and know where they go.
With the installation of all lift kits and larger tires it is important to check
the condition of your steering stabilizer. If the stabilizer is worn or is leaking it should be replaced. Steering stabilizers are
designed to restrain “bump steering” and front end vibration, giving added life to tires, ball joints, and other steering
components. A multiple stabilizer kit is recommended for vehicles equipped with a winch or larger tires
PRODUCT USE INFORMATION
1. As a general rule, the taller a vehicle is, the easier it will roll. Offset, as much as possible, what is lost in rollover
resistance by increasing tire track width. In other words, go "wide" as you go "tall". Many sportsmen remove their mud
tires after hunting season and install ones more appropriate for street driving; always use as wide a tire and wheel
combination as possible to enhance vehicle stability.
2. We strongly recommend, because of rollover possibility, that the vehicle be equipped with a functional roll-bar and cage
system. Seat belts and shoulder harnesses should be worn at all times. Avoid situations where a side rollover may occur
3. Generally, braking performance and capability are decreased when significantly larger/heavier tires and wheels are used.
Take this into consideration while driving.
4. Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Warrior product purchased. Mixing component brands is not recommended.
5. Warrior makes no claims regarding lifting devices and excludes any and all implied claims. We will not be responsible
for any product that is altered.
6. The required installation time for this system is approximately 8 hours.
7. This suspension system was developed using a 33 x 12.50R – 15 tire, on a 8” wheel. Before installing other
combinations, please consult your local tire and wheel specialist.
8. The following tools and supplies are recommended for proper installation of this kit.
a. Spring Compressor
b. Safety Glasses – Wear safety glasses at all times
c. Silicone Spray
d. Wheel Chocks (Wooden Blocks)
e. Drill Assortment (1/8” to 1/2")
f. Heavy Duty Jack Stands
g. Hammer
h. Drill Motor
i. Combination Wrenches
j. Torque Wrench (250 ft lbs. Capacity)
k. Torx Key Socket
l. _” Drive Ratchet and Sockets
m. File
n. Allen Wrenches
o. Hydraulic Floor Jacks
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our products.
FIGURE 1
1