Owner's Manual
Table Of Contents
- Headphones Quick Start Guide
- M1 Amplifier Quick Start Guide
- The Electrostatic Headphone System User Manual
- REVISION HISTORY
- TRANSLATED WARNING AND CAUTION MESSAGES
- BEFORE OPERATION PLEASE READ THESE INSTRUCTIONS
- REGULATORY COMPLIANCE STATEMENTS
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- SYSTEM CONTENTS
- FRONT PANEL CONTROLS
- REAR PANEL CONNECTIONS/CONTROLS
- HEADBAND ADJUSTMENT
- POSITIONING THE HEADPHONES
- CONNECTING THE HEADPHONE CABLE
- DETACHING THE HEADPHONE CABLE
- CONNECTING THE HEADPHONES TO THE AMPLIFIER
- CONNECTING ANALOG AND DIGITAL SOURCES TO THE AMPLIFIER
- ASSEMBLING AND CONNECTING THE POWER SUPPLY UNIT
- POWERING THE UNIT ON
- CHAPTER 3 OPERATION
- CHAPTER 4 COMPUTER-BASED AUDIO SET-UP
- CHAPTER 5 CARE AND MAINTENANCE
- CHAPTER 6 TROUBLESHOOTING
- CHAPTER 7 CUSTOMER SERVICE
- GLOSSARY
- WARRANTY
INSTALLATION
8
POWERING THE UNIT ON
When all connections have been securely made, power the
amplifier/DAC unit ON by flipping the rear panel power
switch to the up position. To power OFF simply depress the
switch to the down position.
Provided all connections have been properly made, the
front panel status indicator should glow WHITE. Your
BRAVURA system is then ready to use.
If the amplifier/DAC detects a fault condition, the status
indicator will glow RED. In this case, first power the unit OFF
and re-check all the connections. If the problem persists,
please refer to the Troubleshooting section.
On
V