Owner's Manual
Table Of Contents
- Headphones Quick Start Guide
- M1 Amplifier Quick Start Guide
- The Electrostatic Headphone System User Manual
- REVISION HISTORY
- TRANSLATED WARNING AND CAUTION MESSAGES
- BEFORE OPERATION PLEASE READ THESE INSTRUCTIONS
- REGULATORY COMPLIANCE STATEMENTS
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- SYSTEM CONTENTS
- FRONT PANEL CONTROLS
- REAR PANEL CONNECTIONS/CONTROLS
- HEADBAND ADJUSTMENT
- POSITIONING THE HEADPHONES
- CONNECTING THE HEADPHONE CABLE
- DETACHING THE HEADPHONE CABLE
- CONNECTING THE HEADPHONES TO THE AMPLIFIER
- CONNECTING ANALOG AND DIGITAL SOURCES TO THE AMPLIFIER
- ASSEMBLING AND CONNECTING THE POWER SUPPLY UNIT
- POWERING THE UNIT ON
- CHAPTER 3 OPERATION
- CHAPTER 4 COMPUTER-BASED AUDIO SET-UP
- CHAPTER 5 CARE AND MAINTENANCE
- CHAPTER 6 TROUBLESHOOTING
- CHAPTER 7 CUSTOMER SERVICE
- GLOSSARY
- WARRANTY
INSTALLATION
6
DETACHING THE HEADPHONE CABLE
Should you need to detach the cable for any reason, grasp
the barrel of the cable and carefully pull backwards until the
cable disconnects. You can then release the barrel and it will
return to its usual position.
CONNECTING THE HEADPHONES TO THE AMPLIFIER
With the cable connected to both ear-cups, connect the
headphone to the amplifier/DAC unit by inserting the cable
into the headphone connector. Be sure to align the red dots
on the connector and chassis. Push the cable into the
connector until it latches.
If you need to detach the cable, grasp the barrel of the
connector and carefully pull backwards until the cable
disconnects, as shown above. Please ensure that the
amplifier is switched OFF before connecting/disconnecting
the headphone cable.
CONNECTING ANALOG AND DIGITAL SOURCES TO THE
AMPLIFIER
NOTE: Before beginning this section, please ensure that the power supply unit is NOT attached, and that the
amplifier/DAC unit’s power switch is in the OFF position!
PRE-OUT
OFF
SPDIF
COAX