User Manual

3) Nut / Bridge

Nut:

Just A Nut III is the standard on RockBass

bass

guitars since 2008, manufactured using high-tech

material with the best tonal characteristics, ne adjus-

tability and stability.

Use the included 1.5 mm Hex Key wrench to adjust

the string’s height at the nut.

Bridge:

The Warwick 3-D Bridge features additional adjustments on the top of the oating bridge: Into-

nation, string spacing as well as individual string saddle height adjustment to accommodate the

ngerboard’s radius.

Tip:

Press down the string at the 3rd fret. Check the distance between the rst fret

and the string. It shouldn’t read more than

0.3 mm (0.01“), which equals the thickness

of a business card.

1. First loosen the locking screw (1) with the included 2.5 mm (0.1“) Hex Key wrench, the bridge is

now unlocked and can be adjusted with the adjustment screws (2).

2. To adjust the height of each individual string saddle as well as adjusting the string spacing, loosen

the locking screws (3) with the included 1.5 mm (0.06“) Hex Key wrench. The saddle can now be

moved sideways to the left or right to obtain the desired string spacing.

3. In this step you can also adjust the height of each individual string saddle, using the 1.5 mm

(0.06“) Hex Key wrench on the height adjustment screws (4). Ideally the strings heights follow the

ngerboard’s radius.

4. You can adjust the intonation screws (5) with a screwdriver. Turning the screws clockwise will

increase the string’s length between bridge and nut; turning them counterclockwise will decrease

the string’s length.

5. Once the setup is done, tighten the locking screws 1 and 3 to lock the bridge in place.