Operating instructions

12
1. Drop the knop into the larger opening in the
supply injector lid.
2. Tighten securely. Do not overtighten! Do not
use pliers or other tools to tighten the knobs!
1. Stretch the multi-rubber ring B and select the
correct size ring which will fit snugly on the
chemical tube you are using. Ring A is used
for tubes with Ø1/3'' (8 mm).
2. Use scissors or a razor to carefully cut out the
proper size rubber ring. Wrap the rubber ring
around each tube after threading each tube
through the plastic nipple. Run the tube
through the compression nut to the bottom of
the compartment. Cut the end of the tube at an
angle. Hand tighten the plastic nipple on to the
compression nut.
Installation
Fig.
22
Fig.
23
22
23
1332
1331
23
1331
Supply injector
Cut to fit
on tube
Multi-rubber ring
Plastic
nipple
Rubber A
rings B
Compression
nut