UD Operator Manual
! WARNING WARNING Before installation and commissioning, you must read theyou safety instructions Before installation and commissioning, must read the safety instructions and warnings and warnings carefully and all the warning labels attached to the equipment. carefully and all the warning labels attached to the equipment.
Safety Instructions WARNING ! ! ! Equipment contains dangerous voltages and can be hazardous if installed or operated WARNING incorrectly. Non-compliance warnings failure to follow the instructions Before installation and commissioning, youwith must read the safety or instructions and warnings carefully all the warning labels attached to the contained in thisand manual can result in loss ofequipment. life, severe personal injury or serious damage to property.
Installation Checklist ! WARNING WARNING Installer must be suitably qualified and ensure compliance with all codes and standards Before installation and commissioning, you must read the safety instructions including AS/NZS3500.1. and warnings carefully and all the warning labels attached to the equipment. Unpack • IMPORTANT !Unpack the machine, check for damage and complete delivery.
UD Installation Diagram UD INST 16-10-14 3C 5 UD - Operator Manual 141216
Machine Operation Turn machine on at wall. Fit scrap tray, filter, upstand and shut door. Press On/ Off Key for 3 Seconds Start key glows white as machine fills. If door is open then the start key glows purple Once full, rinse heating starts. Start key glows orange while heating. Machine can be started when machine is heating. NOTE: If rinse temperature is not sufficient cycle countdown will stop at 22 seconds..
ocedures by Food Hygiene Regulations. The warm water with a Fisher y scraping or dunking in water. warm water, preferably containing er your chemical supplier. Care DAILY CLEANING It is essential that the machine is drained and cleaned at the end of each day. Drain the machine as per the shut down instructions. Remove, clean and replace filters.
Keypad Start Button Colours Machine State Colour Door Open Purple Filling White Heating Orange Ready Green Ecopower Blue Washing Red Error Flashing Red User Programming The User Settings menu is accessed for programming by pressing the UP and DOWN keys simultaneously for a few seconds.
Troubleshooting Fault Cause Remedy Water supply valve shut Check Water supply valve Door Switch not operating Check Door is closed Filling Not filling Filling during wash cycle Upstand not fitted properly Check Drain upstand is fitted Heating Dishes not hot enough Rinsing but not hot Check water arms spinning freely Door switch Check door is closed Water supply cold Check water temperature Detergent not used Use quality low foam product Overloading racks Do not overload racks Not pre-ri
030313 16/12/14 3D EU/UD7 Wiring Diagram UD7(W) WIRING DIAGRAM 11 UD - Operator Manual 141216
Accessories Code Description 600 70029 Cuprack 500mm 600 70028 Dishrack 500mm C660503 G Cutlery Container 12 UD - Operator Manual 141216
Information supplied in this manual is copyright. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical without the express permission of the author/publisher Distributed in Australia by Moffat Pty Limited 740 Springvale Road Mulgrave 3170 Victoria Australia 24HR Service 1 800 622 216 Parts 1 800 337 963 Tel Fax E-mail web 03 9518 3888 03 9518 3818 vsales@moffat.com.au www.moffat.com.
