Operating instructions

SoftCare Evo - Type SE10 3-8
Chapter 3 - Structure and function
The wheel wash brushes are integrated in both side
elements and are driven directly. A light barrier (1)
identifies the wheel.
1 = Light barrier
Fig. 3-8: Light barrier
The wheel wash is executed as described below:
⇒ The light barrier detects the wheel
⇒ The gantry comes to a standstill
⇒ The wheel washing brush is extended /
The high-pressure spray system is switched
on
⇒ The wheel is washed
⇒ The wheel washing brush returns to its start-
ing position / The high-pressure spray system
is switched off
⇒ The gantry starts again
High-pressure wheel washers may be set-up in a
way that also the sills are cleaned. As soon as the
vehicle front is detected the high-pressure spray sys-
tem is switched on and the wheel wash brushes ro-
tate. High-pressure spray system and wheel wash
brushes are switched off at the vehicle rear. The
wheel wash is executed as described before.
Vehicles with rear wheel cladding may be dam-
aged in automatic operating mode (only brush
wheel washer.
)
Control the wheel washing manually (see
Chapter 9 "Operating units").
CAUTION