Operating instructions

SoftCare Evo - Type SE10 4-2
Check brushes
Switching on
Chapter 4 – Commissioning/dismantling/ conversion/
transport/assembly
There is a risk of injury in frosty conditions by
ice formations in the entrance and exit area.
Remove the ice from the entrance and exit area.
)
Check all brushes for foreign parts (dirt, small
stones, etc.) and remove them if necessary.
)
Check all brushes for a tight fitting.
Foreign parts in the brushes and brushes which
are not securely tightened may damage the vehi-
cle.
Make sure that no foreign parts stuck in the
brushes. Clean the brushes periodically (see
chapter 7.2.4).
Make sure that all brushes are tightened se-
curely.
WashTec can accept no responsibility for dam-
age to vehicles which are caused by dirty or
loose brushes.
)
Open the air and water connections.
)
Switch the system on at the main switch.
The roll-over car wash system carries out a self-test
which lasts about 10 seconds.
)
Pay attention to the message displayed on the
operating unit after completion of the self-test.
CAUTION