Service manual

400 90144
19/11/2013
1-G
DRAIN PUMP KIT 0440031 - XP/AL3/AL8/PW1
REV
DRAIN PUMP KIT 0440031
QTYDESCRIPTIONPART NUMBERITEM
1
SWITCH C/RINSE ROLD SPCO
600 301021
4HOSE CLAMP ASS162
1
P CLIP
600 301733
1HOSE DRAIN 2.5M600 601054
1DRAIN PUMP600 601025
1MS HX SS 304 M6 x 12884616
1WASHER SPRING SS 304 M68566-1
7
1
UD UHB25 HOSE BEND
600 900748
1DRAIN PUMP UNION388239
1
GASKET DRAIN PUMP UNION
3882410
1RETROFIT DIAGRAM400 90014411
0.7mWIRE 0.75 YELLOW/BROWN600 3003212
1.5mWIRE 0.75 BLACK600 3001613
0.5mWIRE 0.75 RED600 3001514
0.2mWIRE 0.75 WHITE/BLUE600 3003315
0.2mWIRE 0.75 BROWN600 3002316
7
TERMINAL RED SPADE
H356017
2TERMINAL RED FLATH420718
1
BUTTON WITH DRAIN SYMBOL
600 3029719
1BASE 2 POLE RELAY600 3008120
1
RELAY 2 POLE (240VAC)
600 3008021
40mm3M VHB TAPEREF22
1ASSY DRAIN PUMP FILTER400 1002123
1. Pre-assemble the drain pump with the flexible outlet hose #4, the inlet hose #8, the drain pump union #9.
Secure the hoses with the supplied hose clamps #2.
2. Secure drain pump to base with M6 bolt #6 and the spring washer #7, provided in the kit.
3. Fit the drain union gasket #10 into the drain pump union #9. and screw the drain pump union #9 on to the drain waste of the
machine.
4. Secure drain outlet hose above the water level using P clip #3 supplied in the kit.
5. Cut out the right side hole below the wash temperature gauge in the control panel label (if see from the front). and fit the drain
switch #1. Fit the base and the relay #20 & 21 at the back of control panel using double-sided adhesive tape provided.
6. Wire the drain pump, the drain switch and the drain relay according to electrical diagrams, provided in service manual or
schematic diagram, supplied with the machine.
2
2
5
6
4
7
8
9
10
3
2
1
2
17
18
17
17
17
14
17
15
13
12
TO POWER
TERMINAL
TO SELECTOR
SWITCH
19
13
16
22
20
21
23
Service Manual XP-2
38
Revision 1C