User Manual

No-Drill Mount For Google
Nest Doorbell (Battery)
USER MANUAL
In the Box
Safety Information
∙ Read this manual carefully before use.
Failure to follow the safety instructions may
cause injury or damage to your property.
∙ Keep away from children as it could be a
choking hazard to them.
∙ To be used with the Google Nest Doorbell
(battery) only.
Pre-Installation
Installation
Removing the Mount
FAQ & Support
Get More Support
1. Ensure the designated surface is dry and
clean of any debris.
1. Remove the protective film without
touching the adhesive part.
2. Carefully position the tape and stick the
mount onto a designated surface.
3. Apply pressure over the mount to facilitate
adhesion. A rigid surface may require
additional force.
4. Screw the Google Nest Doorbell (battery)
backplate into the holes as shown.
If a wedge is needed, attach it to the holes
shown instead. Then screw in the doorbell
backplate to the wedge.
5. Attach the doorbell to the backplate.
Note: If solar panel is installed for the
doorbell, connect the wires to the doorbell
and make sure the wires com out from the
opening at both sides.
6. To charge the doorbell, remove it from the
mount using the key that comes with the
doorbell.
1. Remove the Google Nest Doorbell
(battery) and the backplate from the
mount.
3. Easily remove the tape by pulling it
downwards.
4. Clean any remaining adhesive residue left
from the wall.
2. Gently wiggle the mount from side to side
to prevent any damage to the wall surface.
Scan the QR code below or email us at:
[e-mail]
What kind of wall surface can I attach the
mount to?
The outdoor heavy-duty tape allows you to
mount the mount on most even surfaces, such
as a painted wall, pipewood, and glass.
2. For optimal binding, the tape needs to be
installed at a temperature of at least 60°F
(15°C).
Note: For re-installations, make sure there
are no traces of adhesive residue left
before sticking a new tape.
Note: The surface can be damaged when
removing the mount from the wall.
Page 1
Page 4
Page 5 Page 6
Page 2 Page 3
Google Nest Video Doorbell (battery) is not included.
Wasserstein is not affiliated with Google LLC. Wasserstein
is a trademark of Dropcases Ltd. Google Nest Video
Doorbell (battery) is a trademark of Google LLC.
For more information, please visit:
www.wasserstein-home.com
Or contact us at:
[e-mail]
Made in China
1 x no-drill
mount
1 x extra
adhesive tape
2 x short screws
2 x wedge screws
100 mm
100 mm
60 mm
240 mm
Manual for Nest Doorbell mount