Use and Care Manual

ManualsBrandsWaste King ManualsAppliance partsGarbage Disposal Plastic Drain Stopper and Splash Guard

INS10477 - 8/15

ELECTRICAL CONNECTIONS

NOTE: if you are not familiar with electrical power and procedures, call a qualied electrician.

A. Connect the disposal cord to 110-120 volt, 60 Hz AC current only.

B. This waste disposal is equipped with a factory installed plug-in cord with a three prong grounding plug. If a 110-120 volt, 60 Hz AC

grounding outlet is not available, have a proper outlet installed by a qualied electrician.

C. This waste disposal requires that a dedicated switch with a marked “O“ position. The switch shall be installed within sight of the sink

opening or the disposal.

ELECTRICAL CONNECTIONS

NOTE: if you are not familiar with electrical power and procedures, call a qualied electrician.

A. Connect the disposal cord to 110-120 volt, 60 Hz AC current only.

B. This waste disposal is equipped with a factory installed plug-in cord with a three prong grounding plug. If a 110-120 volt, 60 Hz AC

grounding outlet is not available, have a proper outlet installed by a qualied electrician.

C. This waste disposal requires that a dedicated switch with a marked “O“ position. The switch shall be installed within sight of the sink

opening or the disposal.

ELECTRICAL CONNECTIONS

NOTE: if you are not familiar with electrical power and procedures, call a qualied electrician.

A. Connect the disposal cord to 110-120 volt, 60 Hz AC current only.

B. This waste disposal is equipped with a factory installed plug-in cord with a three prong grounding plug. If a 110-120 volt, 60 Hz AC

grounding outlet is not available, have a proper outlet installed by a qualied electrician.

C. This waste disposal requires that a dedicated switch with a marked “O“ position. The switch shall be installed within sight of the sink

opening or the disposal.

OPERATING INSTRUCTIONS

The Anti-Jam Swivel Impellers make a clicking sound as they swing into place. This indicates normal operation.

A. Remove the sink stopper. Turn on a medium ow of cold water.

B. Turn the switch to the “ON” position; your motor is turning at full speed and ready to use.

C. Scrape garbage into the disposal. Down the drain go table scraps, peelings, rinds, seeds, pits, small bones and coee grounds. To speed up garbage disposal, cut or

break up large bones, rinds and cobs. Large bones and brous husks require considerable grinding time and are more easily thrown away with other trash.

Important: Do not be alarmed that the disposal slows down while grinding. The disposal is actually increasing torque (grinding power) and is operating under

normal conditions.

D. Before turning the disposal o, let the water and the disposal run for approximately 15 seconds after shredding stops. This assures that all waste is thoroughly ushed through the

trap and drain.

E. Run cold water during the disposal operation. This will keep waste and fats solid so the disposal can properly ush away the particles. It is not recommended to use hot

water while running the disposal.

OPERATING INSTRUCTIONS

The Anti-Jam Swivel Impellers make a clicking sound as they swing into place. This indicates normal operation.

A. Remove the sink stopper. Turn on a medium ow of cold water.

B. Turn the switch to the “ON” position; your motor is turning at full speed and ready to use.

C. Scrape garbage into the disposal. Down the drain go table scraps, peelings, rinds, seeds, pits, small bones and coee grounds. To speed up garbage disposal, cut or

break up large bones, rinds and cobs. Large bones and brous husks require considerable grinding time and are more easily thrown away with other trash.

Important: Do not be alarmed that the disposal slows down while grinding. The disposal is actually increasing torque (grinding power) and is operating under

normal conditions.

D. Before turning the disposal o, let the water and the disposal run for approximately 15 seconds after shredding stops. This assures that all waste is thoroughly ushed through the

trap and drain.

E. Run cold water during the disposal operation. This will keep waste and fats solid so the disposal can properly ush away the particles. It is not recommended to use hot

water while running the disposal.

OPERATING INSTRUCTIONS

The Anti-Jam Swivel Impellers make a clicking sound as they swing into place. This indicates normal operation.

A. Remove the sink stopper. Turn on a medium ow of cold water.

B. Turn the switch to the “ON” position; your motor is turning at full speed and ready to use.

C. Scrape garbage into the disposal. Down the drain go table scraps, peelings, rinds, seeds, pits, small bones and coee grounds. To speed up garbage disposal, cut or

break up large bones, rinds and cobs. Large bones and brous husks require considerable grinding time and are more easily thrown away with other trash.

Important: Do not be alarmed that the disposal slows down while grinding. The disposal is actually increasing torque (grinding power) and is operating under

normal conditions.

D. Before turning the disposal o, let the water and the disposal run for approximately 15 seconds after shredding stops. This assures that all waste is thoroughly ushed through the

trap and drain.

E. Run cold water during the disposal operation. This will keep waste and fats solid so the disposal can properly ush away the particles. It is not recommended to use hot

water while running the disposal.

GROUNDING INSTRUCTIONS NOTE: if you are not familiar with electrical power and procedures, call a qualied electrician. WARNING – Improper connection of the

equipment-grounding conductor can result in a risk of electric shock. Check with a qualied electrician or serviceman if you are in doubt as to whether the appliance is properly

grounded. Do not modify the plug provided with the appliance. If it will not t into the outlet, have a proper outlet installed by aqualied electrician. THIS DISPOSAL IS EQUIPPED WITH

A GROUNDED PLUG-IN POWER CORD.This appliance must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to

reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate

outlet that is properly installed and grounded in accordance with all local codes and ordinances. (If in doubt, call a qualied electrician).