Hardware Guide

Hardware Description
The access point has these connections on the bottom panel of the device.
Bottom Panel Connections
Reset Button
Resets the access point to factory-default settings.
n Use a paper clip or other small object to press the reset button through the hole.
n Press and hold the reset button for up to 10 seconds. When you release the reset button, all
LEDs will go off to indicate that the device has rebooted.
2.5 G / LAN (PoE+)
This is a 2.5 Gbps Ethernet LAN port that connects the access point to a wired LAN connection
through a switch or hub. This port also provides PoE+ (802.3at) power for the device.
DC 12V
If PoE power is unavailable, you can power the device with the optional 12V DCpower adapter
(WG9009).
WatchGuard AP432 Hardware Guide
9 WatchGuard Technologies, Inc.