User's Manual

6 WatchGuard Firebox T30 / T50
Hardware Specifications
Safety Notices
All WatchGuard products are designed and tested to meet strict safety requirements. These requirements
include product safety approvals and other global compliance standards. Read these instructions carefully
before you operate the product, and refer to them as needed for continued safe operation of your product.
Product Safety Certification
The WatchGuard product is safety certified for these standards:
 CAN/CSA C22.2 No.60950-1-07, Second Edition 2014-10
 UL 60950-1, Second Edition 2014-10-14
 IEC 60950-1, 2005+A1:2009+A2:2013
 EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013
Safety Warning
 Do not place objects on the power cord.
 Do not obstruct the ventilation openings. These openings prevent overheating of the Firebox.
 Never push objects of any kind into slots or openings on this equipment. If you make contact with a
voltage point or short out a part, it can result in fire or electrical shock.
 When you remove or install an appliance, follow the general installation safety instructions provided
in this Hardware Guide to avoid injury or damage to the device.
 You must disconnect the AC power cord from the Firebox before you remove the cover of the Firebox
for any reason.
 There is risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries
according to the manufacturer’s instructions.
Disclaimer
WatchGuard shall not be held liable if the end user alters, modifies, or repairs any WatchGuard hardware
appliance.