User's Manual

Setting up the Firebox X Edge Wireless
78 WatchGuard Firebox X Edge
802.11g and 802.11b
This mode allows Firebox X Edge Wireless to connect with
wireless devices using both wireless protocols
802.11b only
This mode allows the Firebox X Edge Wireless to connect to
devices using this wireless protocol.
Configuring Static Routes
To send the specified packets to different segments of the trusted
network connected through a router or switch, configure static
routes.
Follow these instructions to configure static routes:
1 Type the IP address of the trusted network in your browser
window to connect to the System Status page of the Firebox X
Edge Wireless:
The default IP address is: http://192.168.111.1
2 From the navigation bar on the left side, select
Network > Routes.
The Routes page appears.
3 Click Add.
The Add Route page appears.
4 From the Type drop-down list, select either Host or Network.
5 Type the IP address and the gateway of the route in the
applicable fields.
The gateway of the route is the local interface of the router.
6 Click Submit.
To remove a route, select the route and click Remove.