User's Manual
Table Of Contents
- WatchGuard® Firebox® X Edge User Guide
- Certifications and Notices
- Declaration of Conformity
- Notice to Users
- WatchGuard Firebox Software
- End-User License Agreement
- Copyright, Trademark, and Patent Information
- Limited Hardware Warranty
- Abbreviations Used in this Guide
- CHAPTER 1 Introduction to Network Security
- CHAPTER 2 Installing the Firebox® X Edge
- CHAPTER 3 Configuration and Management Basics
- CHAPTER 4 Changing Your Network Settings
- Using the Network Setup Wizard
- Configuring the External Network
- Configuring the Trusted Network
- Configuring the Optional Network
- Enabling the optional network
- Changing the IP address of the optional network
- Using DHCP on the optional network
- Setting optional network DHCP address reservations
- Configuring the optional network for DHCP relay
- Using static IP addresses for optional computers
- Adding computers to the optional network
- Requiring encrypted connections
- Making Static Routes
- Viewing Network Statistics
- Registering with the Dynamic DNS Service
- Enabling the WAN Failover Option
- Enabling External Modem Failover
- CHAPTER 5 Setting up the Firebox X Edge Wireless
- CHAPTER 6 Configuring Firewall Settings
- CHAPTER 7 Configuring Logging
- CHAPTER 8 Configuring WebBlocker
- CHAPTER 9 Configuring Virtual Private Networks
- CHAPTER 10 Configuring the MUVPN Client
- CHAPTER 11 Managing the Firebox® X Edge
- Viewing Current Sessions and Users
- About User Authentication
- Adding or Editing a User Account
- About Seat Licenses
- Selecting HTTP or HTTPS for Firebox Management
- Changing the HTTP Server Port
- Setting up VPN Manager Access
- Updating the Firmware
- Activating Upgrade Options
- Enabling the Model Upgrade Option
- Configuring Additional Options
- Viewing the Configuration File
- APPENDIX A Firebox®X Edge Hardware
- Index
Installing and Configuring the MUVPN Client
User Guide 131
Installing and Configuring the MUVPN Client
Get the MUVPN installation files from the WatchGuard Web site:
http://www.watchguard.com/support
NOTE
To install and configure the MUVPN client, you must have local
administrator rights on the remote computer.
Installing the MUVPN client
To install the MUVPN client:
1 Copy the MUVPN installation file to the remote computer.
2 Double-click the MUVPN installation file to start the
InstallShield wizard.
3 Click Next.
If the InstallShield stops because of a read-only files error, click Yes to
continue the installation.
4 A welcome message appears. Click Next.
The Software License Agreement appears.
5 Click Yes to accept the License Agreement.
The Setup Type window appears.
6 Select the type of installation. WatchGuard recommends that
you use the Typical installation. Click Next.
7 On a Windows 2000 computer, the InstallShield looks for the
Windows 2000 L2TP component. If the component is installed,
the InstallShield does not install it again. Click OK to continue.
The Select Components window appears.
8 Do not change the default selections. Click Next.
The Start Copying Files window appears.
9 Click Next to install the files.
When the dni_vapmp file is installed, a command prompt window
appears. This is normal. After the file is installed, the command window
closes and the installation is continued.
10 After the installation is complete, click Finish.
11 The InstallShield wizard looks for a user profile. Click Next to
skip this step. You do not need to have an installed user profile.
An information dialog box appears.
12 Click OK to continue the installation.