User's Manual

Configuring the MUVPN Client
134 WatchGuard Firebox X Edge
Configuring MUVPN client settings
The MUVPN client settings apply to all of the Edge’s MUVPN con-
nections. For information on these settings, see “Configuring
MUVPN client settings” on page 151.
Enabling MUVPN access for an Edge user account
1 Type the IP address of the trusted network in your browser
window to connect to the System Status page of the Firebox X
Edge.
The default trusted IP address is https://192.168.111.1.
2 Add a new user or edit an existing user, as described in “Adding
or Editing a User Account” on page 152.
3 Click the MUVPN tab.
4 Select the Enable MUVPN for this account checkbox.
5 Type a shared key in the applicable field.
6 Type the virtual IP address in the applicable field.
The virual IP address must be an address on the Firebox X Edge trusted
network that is not used. This address is used by the remote computer to
connect to the Firebox X Edge.
7 From the Authentication Algorithm drop-down list, select the
type of authentication.
The options are MD5-HMAC and SHA1-HMAC.
8 From the Encryption Algorithm drop-down list, select the type
of encryption.
The options are DES-CBC and 3DES-CBC.
9 Set MUVPN key expiration in kilobytes or hours. The default
values are 8192 KB and 24 hours, respectively.
10 Select Mobile User from the VPN Client Type drop-down list.
11 Select the All traffic uses tunnel (0.0.0.0/0 IP Subnet)
checkbox if the remote client will send all its traffic (including
normal Web traffic) over the VPN to the Firebox X Edge. This
can also let the MUVPN client communicate with other
networks that the Firebox X Edge connects. If this checkbox is
selected, the MUVPN client software must be configured with
the subnet and mask fields set to 0.0.0.0.
12 Click Submit.