User's Manual
Table Of Contents
- WatchGuard® Firebox® X Edge User Guide
- Certifications and Notices
- Declaration of Conformity
- Notice to Users
- WatchGuard Firebox Software
- End-User License Agreement
- Copyright, Trademark, and Patent Information
- Limited Hardware Warranty
- Abbreviations Used in this Guide
- CHAPTER 1 Introduction to Network Security
- CHAPTER 2 Installing the Firebox® X Edge
- CHAPTER 3 Configuration and Management Basics
- CHAPTER 4 Changing Your Network Settings
- Using the Network Setup Wizard
- Configuring the External Network
- Configuring the Trusted Network
- Configuring the Optional Network
- Enabling the optional network
- Changing the IP address of the optional network
- Using DHCP on the optional network
- Setting optional network DHCP address reservations
- Configuring the optional network for DHCP relay
- Using static IP addresses for optional computers
- Adding computers to the optional network
- Requiring encrypted connections
- Making Static Routes
- Viewing Network Statistics
- Registering with the Dynamic DNS Service
- Enabling the WAN Failover Option
- Enabling External Modem Failover
- CHAPTER 5 Setting up the Firebox X Edge Wireless
- CHAPTER 6 Configuring Firewall Settings
- CHAPTER 7 Configuring Logging
- CHAPTER 8 Configuring WebBlocker
- CHAPTER 9 Configuring Virtual Private Networks
- CHAPTER 10 Configuring the MUVPN Client
- CHAPTER 11 Managing the Firebox® X Edge
- Viewing Current Sessions and Users
- About User Authentication
- Adding or Editing a User Account
- About Seat Licenses
- Selecting HTTP or HTTPS for Firebox Management
- Changing the HTTP Server Port
- Setting up VPN Manager Access
- Updating the Firmware
- Activating Upgrade Options
- Enabling the Model Upgrade Option
- Configuring Additional Options
- Viewing the Configuration File
- APPENDIX A Firebox®X Edge Hardware
- Index
Viewing Current Sessions and Users
User Guide 147
• The total length of time of the session
• The time between the last packet and the session expiration.
This is known as the idle time. If you set the idle time to 0 hours
and 0 minutes, the Firebox does not disconnect the session.
Closing a session
To disconnect an active session, click the X for the session. A dialog
box appears. Click Yes to disconnect the session. To disconnect all
active sessions, click Close All.
• The user can log out manually by clicking the Logout button on
[page]. If the user clicks this button, the Login Status box closes,
and a warning dialog bog appears. The logout process is not
complete until the user closes all open browsers.
When a session closes, the seat license is available again for another
user. For more information on seat licenses, see “About Seat
Licenses” on page 156.
Local User Accounts
Below Local User Accounts, you can see information on the users
you configured to use this Edge:
• Name -- The administrator account appears first in the list.
Other users appear in alphanumeric sequence.
• Admin Level -- You can set the user permissions to Full, None,
or Read-only. For more information, see “Adding or Editing a
User Account,” on page 152.
• Options -- You can configure a user to use WebBlocker or
MUVPN. For more information, see “Setting a WebBlocker
profile for a user,” on page 154 and “Enabling MUVPN for a
user,” on page 154.