User's Manual
Table Of Contents
- WatchGuard® Firebox® X Edge User Guide
- Certifications and Notices
- Declaration of Conformity
- Notice to Users
- WatchGuard Firebox Software
- End-User License Agreement
- Copyright, Trademark, and Patent Information
- Limited Hardware Warranty
- Abbreviations Used in this Guide
- CHAPTER 1 Introduction to Network Security
- CHAPTER 2 Installing the Firebox® X Edge
- CHAPTER 3 Configuration and Management Basics
- CHAPTER 4 Changing Your Network Settings
- Using the Network Setup Wizard
- Configuring the External Network
- Configuring the Trusted Network
- Configuring the Optional Network
- Enabling the optional network
- Changing the IP address of the optional network
- Using DHCP on the optional network
- Setting optional network DHCP address reservations
- Configuring the optional network for DHCP relay
- Using static IP addresses for optional computers
- Adding computers to the optional network
- Requiring encrypted connections
- Making Static Routes
- Viewing Network Statistics
- Registering with the Dynamic DNS Service
- Enabling the WAN Failover Option
- Enabling External Modem Failover
- CHAPTER 5 Setting up the Firebox X Edge Wireless
- CHAPTER 6 Configuring Firewall Settings
- CHAPTER 7 Configuring Logging
- CHAPTER 8 Configuring WebBlocker
- CHAPTER 9 Configuring Virtual Private Networks
- CHAPTER 10 Configuring the MUVPN Client
- CHAPTER 11 Managing the Firebox® X Edge
- Viewing Current Sessions and Users
- About User Authentication
- Adding or Editing a User Account
- About Seat Licenses
- Selecting HTTP or HTTPS for Firebox Management
- Changing the HTTP Server Port
- Setting up VPN Manager Access
- Updating the Firmware
- Activating Upgrade Options
- Enabling the Model Upgrade Option
- Configuring Additional Options
- Viewing the Configuration File
- APPENDIX A Firebox®X Edge Hardware
- Index
Installing the Firebox® X Edge
14 WatchGuard Firebox X Edge
N
OTE
N
OTE
If your ISP gives your computer an IP address of 10.0.0.0/8 or one
that starts with 192.168 or 172.16 to 172.31, then your ISP uses
network address translation (NAT). You must get a public IP
address and disable NAT on your intranet router for full
functionality. Get instructions from your ISP.
Your TCP/IP Properties Table
To find your TCP/IP properties, use the instructions for your com-
puter operating system.
Microsoft Windows 2000 and Windows XP
1 Click Start > Programs > Accessories > Command Prompt.
2 At the MS-DOS prompt, type ipconfig /all and then press
Enter.
3 Record the values in the Your TCP/IP Properties Table on
page 14.
4 Close the window.
Microsoft Windows NT
1 Click Start > Programs > Command Prompt.
2 At the MS-DOS prompt, type ipconfig /all and then press
Enter.
TCP/IP Property Value
IP Address
. . .
Subnet Mask
. . .
Default Gateway
. . .
DHCP Enabled Yes No
DNS Server(s) Primary
. . .
Secondary
. . .