User's Manual

Connecting the Firebox X Edge
User Guide 19
• A straight-through Ethernet cable to connect each hub to the
Firebox X Edge.
To connect more than seven devices to the Firebox X Edge:
1 Shut down your computer. If you connect to the Internet
through a DSL modem or cable modem, disconnect the power
supply from this device.
2 Disconnect the Ethernet cable that runs from your DSL modem,
cable modem, or other Internet connection to your computer.
Connect the Ethernet cable to the WAN port on the Firebox X
Edge.
The Firebox X Edge is connected directly to the modem or other Internet
connection.
3 Connect one end of the straight-through Ethernet cable
supplied with your Firebox X Edge to one of the seven
numbered Ethernet ports (labeled 0-6) on the Edge. Connect
the other end to the uplink port of the Ethernet hub or switch.
The Firebox X Edge is connected to the Internet and your Ethernet hub
or switch.
4 Connect an Ethernet cable between each of the computers and
an uplink port on the Ethernet hub, and make sure the link
lights are lit on both devices when powered back on.
5 If you connect to the Internet through a DSL modem or cable
modem, reconnect the power supply to this device. The
indicator lights flash and then stop. The modem is ready for use.
6 Attach the AC adapter to the Firebox X Edge. Connect the AC
adapter to a power supply.
7 Restart your computer.
If you get a message that says your operating system has no network
connection, shut down all equipment and make sure all devices are
connected properly.
8 Start your Internet browser.
9 Type https://192.168.111.1/ into the URL entry field of your
browser and press Enter.
10 Follow the steps in the QuickSetup Wizard to configure your
Firebox X Edge.