User's Manual
Table Of Contents
- WatchGuard® Firebox® X Edge User Guide
- Certifications and Notices
- Declaration of Conformity
- Notice to Users
- WatchGuard Firebox Software
- End-User License Agreement
- Copyright, Trademark, and Patent Information
- Limited Hardware Warranty
- Abbreviations Used in this Guide
- CHAPTER 1 Introduction to Network Security
- CHAPTER 2 Installing the Firebox® X Edge
- CHAPTER 3 Configuration and Management Basics
- CHAPTER 4 Changing Your Network Settings
- Using the Network Setup Wizard
- Configuring the External Network
- Configuring the Trusted Network
- Configuring the Optional Network
- Enabling the optional network
- Changing the IP address of the optional network
- Using DHCP on the optional network
- Setting optional network DHCP address reservations
- Configuring the optional network for DHCP relay
- Using static IP addresses for optional computers
- Adding computers to the optional network
- Requiring encrypted connections
- Making Static Routes
- Viewing Network Statistics
- Registering with the Dynamic DNS Service
- Enabling the WAN Failover Option
- Enabling External Modem Failover
- CHAPTER 5 Setting up the Firebox X Edge Wireless
- CHAPTER 6 Configuring Firewall Settings
- CHAPTER 7 Configuring Logging
- CHAPTER 8 Configuring WebBlocker
- CHAPTER 9 Configuring Virtual Private Networks
- CHAPTER 10 Configuring the MUVPN Client
- CHAPTER 11 Managing the Firebox® X Edge
- Viewing Current Sessions and Users
- About User Authentication
- Adding or Editing a User Account
- About Seat Licenses
- Selecting HTTP or HTTPS for Firebox Management
- Changing the HTTP Server Port
- Setting up VPN Manager Access
- Updating the Firmware
- Activating Upgrade Options
- Enabling the Model Upgrade Option
- Configuring Additional Options
- Viewing the Configuration File
- APPENDIX A Firebox®X Edge Hardware
- Index
Rebooting the Firebox
User Guide 43
The Firebox reboot cycle is up to 30 seconds. During the reboot
cycle, the mode light on the front of the Firebox turns off and then
turns on again.
Local reboot
You can locally reboot the Firebox X Edge either with the Web
browser or by disconnecting the power supply.
Using the Web browser
1 Type the IP address of the trusted network in your browser
window to connect to the System Status page of the Firebox X
Edge.
The default IP address is: https://192.168.111.1
2 Click Reboot.
Disconnecting the power supply
Disconnect the Firebox power supply. After a minimum of 10 sec-
onds, connect the power supply.
Remote reboot
You must configure the remote Firebox X Edge to send incoming
HTTP (Web) or FTP traffic to the Firebox’s trusted interface IP
address if you want to use the following method to reboot it. For
more information on how to configure the Firebox to receive incom-
ing traffic, see “Configuring Incoming and Outgoing Policies” on
page 65. Also, see the following FAQ for more information on con-
figuring a Firebox X Edge to receive incoming traffic: