User's Manual

Changing Your Network Settings
46 WatchGuard Firebox X Edge
4 Work through the wizard, following the instructions on the
screens. Steps associated with optional functionality you decide
not to enable are automatically skipped by the wizard.
The Network Setup Wizard consists of the following steps:
Step 1: Welcome
The first screen describes the purpose of the wizard.
Step 2: Configure the External Interface of your Firebox
The next screen asks the method your ISP uses to set your IP
address. For more information, see the next section in this guide,
“Configuring the External Network.”
Step 3a: Configure the External Interface for DHCP
On the next screen, type in your DHCP identification as provided
by your ISP. For more information, see “If your ISP uses DHCP”
on page 47.
Step 3b: Configure the External Interface for PPPoE
On the next screen, type in your PPPoE information as provided
by your ISP. For more information, see “If your ISP uses PPPoE”
on page 48.
Step 3c: Configure the External Interface with a static IP
address
On the next screen, type in your static IP address information as
provided by your ISP. For more information, see “If your ISP uses
static IP addresses” on page 48.
Step 4: Configure the Trusted Interface of the Firebox
On the next screen, type the IP address of the trusted interface.
For more information, see “Configuring the Trusted Network” on
page 50.
Step 5: Change the User Name and Passphrase
The next screen enables you to set a username and passphrase
for the Edge.
Step 6: The Network Setup Wizard is complete
Configuring the External Network
You must configure your external network manually if you choose
not to use the Network Setup wizard.