Design for Manufacturing and Environment Document SOHO 6 Wireless De-manufacturing Instructions Document Number: 480-2523-001 WatchGuard Technologies. Doc #480-2523-001 Rev.
Design for Manufacturing and Environment Document 1.0 Purpose This instruction defines the de-manufacturing process for the recovery of this product family as it pertains to recycling of the major product components. 2.0 Scope This instruction applies to the following product family and family part numbers. Product Family Name Family part #’s (not necessarily inclusive) Firebox SOHO 6 Wireless • Firebox SOHO 6 Wireless; all revisions WatchGuard Technologies. Doc #480-2523-001 Rev.
Design for Manufacturing and Environment Document 3.0 Instruction 3.1 -Remove wireless antenna and antenna hardware Material removed (P/N & material type) Instruction visual Antenna 1305-002 - TPE, PC, reverse SMA connector, RG178 coaxial cable; 2.4Ghz; 2 ea. Remove antenna by unscrewing from chassis post, 2 sides Washer No p/n - Gold plated brass; 2 ea. Nut No p/n - Gold plated brass Remove hardware; 2 sides WatchGuard Technologies. Doc #480-2523-001 Rev.
Design for Manufacturing and Environment Document 3.2 -Remove labels, rubber feet and screw, and separate top from bottom Material removed (part Desc or P/N & material type) Instruction visual Labels Cert. label – Metalized poly-film Serial number: 0823-00x - Poly-film Transmit Cert/FCC/CE: 2111-00x – Metalized Poly-film Rubber Feet 1422-002 - Polyurethane, 4 ea. Remove rubber feet Remove labels Remove screw 0863-003 - Phillips head, stainless steel Remove screw Separate top from bottom 3.
Design for Manufacturing and Environment Document Material removed (P/N & material type) Instruction visual Screws 0863-002 - Phillips head, stainless steel, 3 ea Remove PCBA screws -3 ea. Separate PCBA from chassis bottom 3.4 – Remove EMI shielding WatchGuard Technologies. Doc #480-2523-001 Rev.
Design for Manufacturing and Environment Document Material removed (P/N & material type) Instruction visual Painted metal enclosure 22Ga. EG w/powder coat (Interpon 700 epoxy/polyester) EMI Shielding Mylar Remove EMI shielding. 3 places 3.5 – Remove bezel from unit top - depress tabs to disengage Material removed (P/N & material type) Instruction visual Painted metal enclosure 22Ga. EG w/powder coat (Interpon 700 epoxy/polyester) Bezel PC/ABS Depress tabs to disengage 3.
Design for Manufacturing and Environment Document Material removed (P/N & material type) Screw 0863-002 - Phillips head, stainless steel Instruction visual Remove screw on bottom side of board Module clip PC/ABS Main PCBA Printed circuit assembly WatchGuard Technologies. Doc #480-2523-001 Rev.
Design for Manufacturing and Environment Document 3.7 –Disconnect RF cables from RF module Material removed (P/N & material type) Instruction visual RF Module Mini-PCI module with RF PCBA RF Cable Coaxial cable assembly. 6cm RF Cable Coaxial cable assembly. 19.5cm Remove RF Cables from RF PCBA 4.0 Applicable Documents 5.0 Revision History REV. NO. A REV. DATE 10/10/2005 REVISED SECTION n/a REASON Initial Release ECO# 0712 WatchGuard Technologies. Doc #480-2523-001 Rev.
