- WatchGuard SOHO User Guide SOHO and SOHO|tc 2.3

Configuring your public network

5 Enter the TCP/IP settings you copied from the computer when

you started the install process.

6Click Submit.

To complete SOHO Public Network configuration, see “Release

and renew the IP configuration” on page 19.

Configuring SOHO public network for PPPoE

While less common, PPPoE is another method for an ISP to assign

addresses. Check the information and manuals sent to you by your

ISP to see if they use PPPoE. If you cannot find this information,

contact your ISP and ask. You will need your PPPoE login name

and password.

NOTE

The option to use PPPoE with the WatchGuard SOHO is available with

firmware version 2.0 or later.

To configure the SOHO for PPPoE:

1 Open your Web browser and click Stop.

At this point, the Internet connection is not fully configured, and the

computer cannot load your home page from the Internet. However, the

computer can access special configuration Web pages installed on the

SOHO itself.

2 Using your Web browser, go to http://192.168.111.1.

If this does not work, see “Troubleshooting installation and network

configuration” on page 25.

3Click Public Network.

The Public Network page appears.

4Scroll down to PPPoE Client.